Subie newbie Young 360

Place to come in and say HI to the club after you have registered

Moderators: Subie Gal, 2stroketurbo

Post Reply
Message
Author
lawverdict
360 Newbie
Posts: 117
Joined: 12 years ago
Location: Huntington Beach, CA

Subie newbie Young 360

#1 Post by lawverdict »

Picked up a 360 last week that had been garaged since 1996. Missing Young steering wheel and front seats. I need a lot of parts. The photos tell the story.
I used the bed sides on my harbor freight trailer and $12 of lumber to make a car trailer.
Image

Towed it home and parked in the front yard.
Image
Image
Image
Image
Image

Brakes first.
Image
Image
Image
Image

If anyone has the following for sale, I would like to talk to you:
Front hood latch
Front hood emblem
Air cleaner housing
Muffler
Rim/Wheel
Front bumper
Boot for steering rack
Rear seat any condition
Battery bracket
All boots for engine ducting
Left door striker-the round pin
Hub caps
Young steering wheel
Young bucket seats
Dome lens
Parking brake cables
Headlight eyebrow
Points
Condenser
Distributor cap
Rotor
Rubber timing inspection plug.

Cleaned oil tank and put in fresh oil. Fresh oil in transmission. 12 volts to battery lead, ignition on and no power to coil. Pulled the spark plugs and they had never been fired (probably why the vehicle was parked in 1996). Put 30 weight into cylinders, by pass ignition system with 12 v directly to starter and turned engine over a few times. 12v to coil and no spark. Adjust points, no spark at points. Clean points with point file and now spark at points and plugs. Open carb butterfly, spray fuel in carb throat and the engine runs! Working on fuel tank , fuel diaphragm disintegrated. Awaiting new fuel diaphragm from Jon.

Cheers,
Mike

rogerbhp
360 Master
Posts: 1765
Joined: 20 years ago
Location: LA, California

Re: Subie newbie Young 360

#2 Post by rogerbhp »

Welcome! Where do you live? Billy Paul has just made excellent reproductions of the dome lens. Good luck with your car. Roger Ward

2stroketurbo
360 Master
Posts: 5177
Joined: 20 years ago
Location: Portland Or. Where we avg 77 days of sunshine per year. Whoopee!
Contact:

Re: Subie newbie Young 360

#3 Post by 2stroketurbo »

Congrats, you are getting busy already !
ImageImageImage

User avatar
kjrcace360fan
360 Master
Posts: 3169
Joined: 16 years ago
Location: Charleston, West Virginia

Re: Subie newbie Young 360

#4 Post by kjrcace360fan »

Nice looking young. I happen to have one too. Body looks really good and unmolested. Nice find.

Drop your oil pump before you go any farther. If it is turning easily by hand take the top off and make sure the worm gear has good teeth. Little John was covered with dirt and the oil line was cut and packed with dirt. I was sure the oil pump would be trashed but after a thorough cleaning It seems to function well. They are hard to find and easy to ruin and fix if the parts don't get ruined in the process.
Spud the Orange Young, Hippie (Sold), DB1 Yatch car, DB2 Cheesburger dune buggy, DB3 Burrito one of two known

User avatar
carlofsumner
360 Master
Posts: 710
Joined: 14 years ago
Location: Tacoma, WA USA
Contact:

Re: Subie newbie Young 360

#5 Post by carlofsumner »

Welcome to the club. If the parts are to be found, you will find them here, plus all the help you need from seasoned 360 veterans.
Carl D
1968 Ultra Van 400 - referred to as a whale and named The Righteous Coach
1970 Subaru sedan- referred to as an Orca chaser

oldone
360 Master
Posts: 4790
Joined: 15 years ago
Location: Norman Okla / OU SOONERS Thunder

Re: Subie newbie Young 360

#6 Post by oldone »

kjrcace360fan wrote:Nice looking young. I happen to have one too. Body looks really good and unmolested. Nice find.

Drop your oil pump before you go any farther. If it is turning easily by hand take the top off and make sure the worm gear has good teeth. Little John was covered with dirt and the oil line was cut and packed with dirt. I was sure the oil pump would be trashed but after a thorough cleaning It seems to function well. They are hard to find and easy to ruin and fix if the parts don't get ruined in the process.

Welcome Nice find.
If it's been running the pump is free Or if it was stuck, the pinion is more than likely stripped now.

lawverdict
360 Newbie
Posts: 117
Joined: 12 years ago
Location: Huntington Beach, CA

Re: Subie newbie Young 360

#7 Post by lawverdict »

I live in Orange County, CA. Thank you for the advice on the oil pump. I will look at it after I finish the brakes.

Garm
360 Master
Posts: 3863
Joined: 15 years ago
Location: SoCal USA
Contact:

Re: Subie newbie Young 360

#8 Post by Garm »

I have an extra Young wheel. no horn button I think

User avatar
Eric_Stollsteimer
Posts: 36
Joined: 12 years ago
Location: Los Angeles, CA
Contact:

Re: Subie newbie Young 360

#9 Post by Eric_Stollsteimer »

Glad to see someone bought this one. I made them an offer, but they were sticking to the asking price, so I passed. Probably better that I didn't buy it since I already have three other projects going already. When you get it running, we should hang. I'm in Los Angeles. Oh by the way, the interior panels in your car are for a Deluxe, not a Young. If you are planing on getting the correct ones and want to sell the red ones, let me know. I need them for the 69 Deluxe we are restoring.
-Eric Stollsteimer
1959 VW Single Cab
1971 Honda Z600 Coupe
http://www.cavemanvintage.com

lawverdict
360 Newbie
Posts: 117
Joined: 12 years ago
Location: Huntington Beach, CA

Re: Subie newbie Young 360

#10 Post by lawverdict »

Eric_Stollsteimer wrote:Glad to see someone bought this one. I made them an offer, but they were sticking to the asking price, so I passed. Probably better that I didn't buy it since I already have three other projects going already. When you get it running, we should hang. I'm in Los Angeles. Oh by the way, the interior panels in your car are for a Deluxe, not a Young. If you are planing on getting the correct ones and want to sell the red ones, let me know. I need them for the 69 Deluxe we are restoring.
I plan on being on the road in about 2 weeks and looking forward to cruising PCH. I plan to take care of the mechanicals and interior, take it apart again and paint. Where in Los Angeles are you located? We will be installing new interior panels, but note that the panels I have are warped and one of the rear quarters broke in half. The material is in decent shape.

User avatar
Eric_Stollsteimer
Posts: 36
Joined: 12 years ago
Location: Los Angeles, CA
Contact:

Re: Subie newbie Young 360

#11 Post by Eric_Stollsteimer »

lawverdict wrote:
Eric_Stollsteimer wrote:Glad to see someone bought this one. I made them an offer, but they were sticking to the asking price, so I passed. Probably better that I didn't buy it since I already have three other projects going already. When you get it running, we should hang. I'm in Los Angeles. Oh by the way, the interior panels in your car are for a Deluxe, not a Young. If you are planing on getting the correct ones and want to sell the red ones, let me know. I need them for the 69 Deluxe we are restoring.
I plan on being on the road in about 2 weeks and looking forward to cruising PCH. I plan to take care of the mechanicals and interior, take it apart again and paint. Where in Los Angeles are you located? We will be installing new interior panels, but note that the panels I have are warped and one of the rear quarters broke in half. The material is in decent shape.
Great to hear you're going to have it on the road so quickly! I live in the Glassel Park neighborhood of Los Angeles near Silverlake and Eaglerock. I would still be interested in the door panels even if they are warped since at this point I have nothing at all. I may be able to use the material at least. Give me a call at (313)515-4770 or email me at bossguitar@aol.com anytime. -Eric
-Eric Stollsteimer
1959 VW Single Cab
1971 Honda Z600 Coupe
http://www.cavemanvintage.com

2stroketurbo
360 Master
Posts: 5177
Joined: 20 years ago
Location: Portland Or. Where we avg 77 days of sunshine per year. Whoopee!
Contact:

Re: Subie newbie Young 360

#12 Post by 2stroketurbo »

lawverdict wrote:
Eric_Stollsteimer wrote:Glad to see someone bought this one. I made them an offer, but they were sticking to the asking price, so I passed. Probably better that I didn't buy it since I already have three other projects going already. When you get it running, we should hang. I'm in Los Angeles. Oh by the way, the interior panels in your car are for a Deluxe, not a Young. If you are planing on getting the correct ones and want to sell the red ones, let me know. I need them for the 69 Deluxe we are restoring.
I plan on being on the road in about 2 weeks and looking forward to cruising PCH. I plan to take care of the mechanicals and interior, take it apart again and paint. Where in Los Angeles are you located? We will be installing new interior panels, but note that the panels I have are warped and one of the rear quarters broke in half. The material is in decent shape.

I have rear Sedan seat, it's REALLY bad, Nasty bad, but I saved it for a template if your interested
ImageImageImage

User avatar
books1
360 Master
Posts: 5817
Joined: 15 years ago
Location: Perth, Western Australia ..... Young SS downunder

Re: Subie newbie Young 360

#13 Post by books1 »

Welcome to the Club from downunder, Mike - looks like you are already well on your way to a successful restoration!

Cheers,

Ian

lawverdict
360 Newbie
Posts: 117
Joined: 12 years ago
Location: Huntington Beach, CA

Re: Subie newbie Young 360

#14 Post by lawverdict »

2stroketurbo wrote:
lawverdict wrote:
Eric_Stollsteimer wrote:Glad to see someone bought this one. I made them an offer, but they were sticking to the asking price, so I passed. Probably better that I didn't buy it since I already have three other projects going already. When you get it running, we should hang. I'm in Los Angeles. Oh by the way, the interior panels in your car are for a Deluxe, not a Young. If you are planing on getting the correct ones and want to sell the red ones, let me know. I need them for the 69 Deluxe we are restoring.
I plan on being on the road in about 2 weeks and looking forward to cruising PCH. I plan to take care of the mechanicals and interior, take it apart again and paint. Where in Los Angeles are you located? We will be installing new interior panels, but note that the panels I have are warped and one of the rear quarters broke in half. The material is in decent shape.

I have rear Sedan seat, it's REALLY bad, Nasty bad, but I saved it for a template if your interested
I don't have anything and I don't even know what the rear seats look like! One piece? Two piece? If not too much trouble, I would appreciate a photo.

Post Reply